Floor Oil Furnace Upright

[post_title]

Description:

INFORMATION Flood Home Heating Oil Before the Flood Because fuel oil is lighter than water, flood waters that enter an enclosed basement and are deep enough

Propane/LP space heater (floor/wall units) Oil Furnace Oil Boiler (hot water/steam pipes) Geothermal heat pump Upright . N/A Chest Upright Chest . Defrost Type Manual Frost-Free Manual Frost-Free Manual Automatic

Gas Furnace FIGURE 8: Combustible Floor Base Accessory FIGURE 9: Horizontal Application This furnace may be installed in a ho rizontal position on either side as shown above. It must not be installed on its back. FURNACE WARMAIR PLENUM WITH 1” FLANGES

This furnace must be installed on a non-combustible floor surface such as upright plate on the Smoke Bypass Damper sliding plate, Primary Furnace (natural gas, electric, oil) Location of Fixed Back Draft Damper to be installed on

P-HMX14F10001 and P-HMX20F12001 are oil fired ____ Up Flow ONLY furnaces, Installation on a combustible floor requires a clearance of 1 inch. furnace. Oil flows as long as the oil primary control senses flame.

Rotate the oil burner assembly to be in the upright position. above the floor, on an inside wall where there is good natural air circulation, and where the thermostat will be P-HMX SERIES OIL FURNACE CONTINUOUS FAN OPERATION:

Rear lower side of the right furnace upright. Make hydraulic hose connections and electric power connec-tions per appropriate schematic drawings, Be aware of oil on the floor in the area of your oil filters. This usually means that your canister seal has gone bad.

FIRING RATE NO.2 OIL 140,000BTU/GAL GPH 9 12 14.9 17.9 20.9 23.9 29.9 37.4 n Cooler furnace gases are lo-cated at the bottom of the vessel where scale is most located away from the floor, helping eliminate the possibility of water coming in contact with

Natural Gas, Propane, Oil or Combination Gas/Oil Firing Air Deliveries From Floor Mounted Upright CF-250 Counterflo Heater DUCT FURNACE PRESSURE DROP (IN.W.C.) .60 1.20 .375 .50 .75 1.05 EXHAUSTER MOTOR HP

Design of Furnace with Fuel Oil.xls 77 Design of Furnace with This type of cylindrical upright, tube in horizontally while the burner is located on the floor furnace, so that the flame is not

Bustion air tube to the furnace combustion air collar using a 1/2 inch sheet metal screw. (Screw hole provided The gas line may be installed through the furnace floor or fur-nace side to the gas valve. A dirt leg may be required by some local codes to trap mois-

An oil-fired furnace for installation in a residential garage must be installed as specified in “Installa-tion Location” section (page 3), of these instruc-tions. Notice to the Installer: Installation of this oil-fired furnace – must be per

GAS FURNACE SAFETY Table of Contents GAS FURNACE SAFETY (46 cm) above the floor for a garage installation. Failure to follow these instructions can result in death, explosion, or fire. Explosion Hazard Do not install this furnace in a mobile home.