[post_title]
Description:
This furnace installation. 7. A furnace shall be installed so electrical components Evaporator and furnace condensate drain piping may be manifolded together. A primary drain vent stack must be installed and terminated below the outlet of
Product Description of [post_title] below:
Domestic Shipping: This item is also available for shipping to select countries outside the U.S.
International Shipping: This item is not eligible for international shipping.
Average Customer Review: 9/10
INSTALLATION & OPERATING INSTRUCTIONS for GMPN CONDENSING GAS FURNACE (CATEGORY IV) GMPN, GSUS, or GSU furnace manufactured by GOODMAN. DO NOT install the vent pipe within six (6) CONDENSATE DRAIN This furnace is designed to remove both sensible and latent heat from the combustion flue gas.
Goodman Manufacturing Company, L.P. © 1997-2007 5151 San Felipe, Suite 500, Houston, TX 77056 side as the furnace’s condensate drain trap, or if the installa-tion supports five tons of airflow (two side return air ductwork connections).
AVPTC**14** © 2013 Goodman Manufacturing Company, L.P. 5151 San Felipe, Suite 500, Houston, Special Warning for Installation of Furnace or Air Handling Units in Enclosed Areas such as Garages, A secondary condensate drain connection has been provided
The primary condensate drain. CAUTION Be sure that the coil is installed level or with a slight slope furnace is larger than the drain pan is either direction, any existing gap must be closed off to prevent bypass of air around the coil and drain pan.
GMH95/GCH95/GCH9 GAS-FIRED WARM A IR FURNACE Goodman Manufacturing Company, L.P. 5151 San Felipe, Suite 500, towards the furnace, to properly return condensate to the furnace’s drain system. Allowances should be made for minor expansion
This presentation will primarily focus on these guidelines and other best practices for furnace Condensate (Drain Pan and Safety Switch) Goodman Furnace Installation Manual . 7
Installer’s Guide ALL phases of this installation must comply with NATIONAL, of furnace / air handler condensate drain connection. Close as possible Figure 2 G. CONDENSATE DRAIN PIPING Condensate drain connections are located in the drain pan
Gas Furnace GMS95 GAS $AVER 95% AFUE 95% AFUE Models Qualify for a $150 Tax Credit Goodman® or Distinctions Air Flow Direction M: Upflow/Horizontal CONDENSATE DRAIN TRAP w/ 3/4" PVC DISCHARGE (RIGHT OR LEFT SIDE) 3/4 40 3/4 2 1/16 2 BOTTOM KNOCK-OUT C B D
DO NOT USE PLASTIC DRAIN PANS ON ANY OIL OR DRUM TYPE FURNACE. FOR THESE APPLICATIONS, foot towards the drain. • Install condensate drain lines in accordance with local building codes. but should not be connected to the primary drain line of the coil.
GMS95 95% AFUE GMS95 Models Qualify for a $150 Tax Credit Goodman® or Distinctions Air Flow Direction M: Upflow/Horizontal CONDENSATE DRAIN TRAP w/ 3/4" PVC DISCHARGE (RIGHT OR LEFT SIDE) 3/4 40 3/4 2 1/16 2 BOTTOM KNOCK-OUT C B D FRONT VIEW 16 5/8 A
Condensate Drain 4 .. − 5 Waste Line Connection plate must be installed between the drain pan and the furnace or air handler cabinet to prevent condensation inside the cabinet. INSTALLATION INSTRUCTIONS TXV Coils: EDM, EDD, EDA
Trane has a policy of continuous product and product data improvement and it reserves the right to change specifica-tions and design without notice.
RESIDENTIAL GAS FURNACE MODELS: TG9S*MP, GG9S*MP (95.5% AFUE Single Stage Multi-position) INSTALLATION MANUAL line from the furnace. • The condensate drain lines must not pass through unconditioned spaces where the temperature may fall below freezing.
Certificate from Trane. No additional warranty, either written or implied, is extended by the Manufacturer without an Extended Warranty Restricted or plugged furnace Condensate drain. 1. Adjust thermostat. See operating instructions. 2. Replace or reset protective device or call for