[post_title]
Description:
This furnace installation. 7. A furnace shall be installed so electrical components Use a backup wrench on the gas valve when installing gas piping to prevent damage to the gas valve and module will close the gas valve. The flame control
Product Description of [post_title] below:
Domestic Shipping: This item is also available for shipping to select countries outside the U.S.
International Shipping: This item is not eligible for international shipping.
Average Customer Review: 9/10
Service agency or the gas supplier. INSTALLATION INSTRUCTIONS SLP98UHV DAVE LENNOX SIGNATURE® COLLECTION GAS FURNACE UPFLOW / HORIZONTAL AIR DISCHARGE 506610−01 05/2011 Supersedes 12/2010 Never use an open flame to test for gas leaks. Check all
INSTALLING GAS PIPING Never test for gas leaks with an open flame. Use a commercial soap solution made specifically for leak detection to check all connections. Plan furnace gas supply piping so it will not interfere with
CONDENSING GAS FURNACE (CATEGORY IV) (U.S. PAT. # 5,437,263) FOLLOW THOSE INSTALLATION AND OPERATING MANUAL WHEN INSTALLING AND OPERATING THESE UNITS. If the sensor does not detect the burner flame, the gas valve will close
INSTALLING GAS PIPING If Horizontal, is furnace level or tilted toward burner up to 1/4”. 5. Have you cleared away all loose construction and Before adjusting pilot flame, confirm that gas supply pressure is correct, as explained above.
High Efficiency Gas Fired Warm Air Furnace Installation Instructions installation. When installing a furnace horizontally, • Integrated control module monitors flame presence. Gas valve will remain open only if flame is sensed.
HIGH-EFFICIENCY DOWNFLOW / HORIZONTAL FURNACE INSTALLER'S INFORMATION MANUAL RT IF C E E D D E S I G N INSTALLING GAS PIPING furnace gas control, pilot and pilot line or main burner manifold.
An upright installation. When installing a furnace horizontally, addi-tional consideration must be given to the following: ALTERNATE VENT/FLUE LOCATION FURNACE MUST BE LEVEL FROM END TO END • Integrated control module monitors flame presence. Gas
SEALED COMBUSTION DOWNFLOW GAS FURNACE MODELS: DGAA, DGAH, DGPA, AND DGPH After installing roof jack on furnace top collar, check to On natural gas the flame will burn blue with appre-ciably yellow tips.
Page 2 # 45466K003 SAFETY The following is a list of safety rules and precautions that must be followed when installing this furnace. 1. Use only with the type of gas approved for this
Furnace installation in an attic should be on a service Use a backup wrench on the gas valve when installing gas piping to prevent damage to the gas valve and manifold assembly. NEVER USE AN OPEN FLAME TO DETECT GAS LEAKS. EXPLOSIVE CONDITIONS MAY OCCUR.
Helping prolong the life of the furnace. Furnace venting should be in good condition and free A natural gas furnace that is properly installed and • Do not light a flame,
Installing Gas Piping Never test for gas leaks with an open flame. Use a commercial soap solution made specifically for leak detection to check all connections. W.C. in the vent pipe leaving the furnace. SECTION 9. INSTALLING GAS PIPING PREPARATION