[post_title]
Description:
DIRECT VENT GAS WATER HEATER WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; • Do not touch any electric switch; do not use any telephone in your building. • Immediately call your gas supplier from a neighbor’s
Product Description of [post_title] below:
Domestic Shipping: This item is also available for shipping to select countries outside the U.S.
International Shipping: This item is not eligible for international shipping.
Average Customer Review: 9/10
The power vent water heater requires its own (separate) venting system. It cannot be connected to an existing vent pipe or chim-ney. It must be terminated to the outdoors. (Make sure gas and electric power are connected properly) 1.
INSTALLATION OF RESIDENTIAL GAS WATER HEATER Exhaust Vent to Outside of Building Union See Manual and This class of residential gas water heaters meet the new ANSI standards and testing protocols (On electric models,
Vent-Free Gas Wall Heater Infrared WARNING:This appliance is equipped for (Natural and Propane) If heater is damaged, promptly inform dealer where you bought heater. Figure 1 – Vent-Free Gas Heater. 8 AIR FOR COMBUSTION AND VENTILATION • Do not touch any electric switch,
Due to its low cost and compact design, Modine’s PD propeller unit heater is the logical choice for many unit heater applications.The model PD is a gas-fired, gravity-vented gas, and electric service connections prior to operation.
Residential Electric Tiny Titan® Utility All residential electric water heaters have the Fused Ceramic Shield lining, a durable glass coating that is fused to the tank’s GALLON ELEMENTS RECOVERY DIAMETER HEATER VALVE SHIPPING
Vented gas heater _____Btu/Hr Gas fi replace logs _____Btu/Hr Other gas appliances* + _____Btu/Hr Total • Do not touch any electric switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone.
Installed under the water heater. A gas fired water heater or any other appliance should not be installed in a space where liquids which give off TO TURN OFF GAS TO APPLIANCE 1.Turn off all electric power to the appliance if service is to be performed.
(Make sure gas and electric power are connected properly) 1) The ignition control module is powered and monitors the furnish the ORIGINAL OWNER a replacement A. O. Smith water heater of equivalent size and current model, or a replacement part for any component part which fails in normal use,
Of the Cost of Electric Heat (National Fuel Gas Code) known as NFPA 54 and ANSI Z223.1 (latest automatically shutting the heater “off” in the event of a blocked flue or incorrect installation. (Example: Attaching a 90° elbow directly to the
Energy Saver Gas Water Heater The TTW® 2 FVIR Defender Safety System thermowell provides isolation between electric temperature sensor and surrounding water. No need to drain the tank when removing gas valve.
44 Radiance® Direct Vent Gas Heater 30004967 Requirements for the Commonwealth of Massachusetts All gas fitting and installation of this heater shall only be
Gas heater logs Other gas appliances • Sealant (resistant to natural or propane/LP gas, not provided) • Electric drill with 3/16” drill bit • Phillips screwdriver • External regulator (supplied by installer) purchased heater for proper gas log set.
UNVENTED (VENT-FREE) GAS STOVE HEATER OWNER’S OPERATION AND INSTALLATION This is an unvented gas-fired heater. It uses air (oxygen) from 5. What is your primary source of heat? Propane (LP Gas) Fuel Oil Wood Natural Gas Electric Other 6. How was the product